Parking Padding Solutions - Park with confidence!

  • Home
  • About
  • Products
    • Column Protection >
      • CUSTOM Column Padding
      • Park Sentry Square Column
      • Park Sentry Round Column Protection
      • Sentry Concrete Wrap
    • Corner Protection >
      • Corner Senty
      • Rubber Corner Guards
      • Custom Padded Corner Guards
    • Bollard Covers and Posts >
      • CUSTOM Bollard Padding
      • CUSTOM Cushioned U-Shaped Bollard Padding
      • Bollard Post Covers
      • Sentry Guard Posts
    • CUSTOM Gate Arm Padding and Gate Arm Padding Plus+
    • Height Guard Clearance Bars & Clearance Structures
    • Light Pole Base Cover >
      • CUSTOM Light Pole Base Cover
      • Light Pole Guard - Poletector
    • Other Products >
      • Park-It Parking Curbs
      • Easy Rider Speed Bump
      • Safety Rider Mini Speed Hump
    • Wall Protection >
      • CUSTOM Wall Padding
      • Park Sentry Wall System
      • Rubber Wall Guard
  • FAQs
  • How To Measure
  • Contact Us
  • Blog

How To Measure

PLEASE NOTE:  When measuring, measure carefully and double-check your measurements. 
​Custom pads are made to order and are not returnable.

​CUSTOM COLUMN PADDING
Picture
​​Please provide measurements in inches. 

​Columns tend to vary in size from top to bottom. For the most accurate measurement, measure the column at 3 different places:  
     - the base
     - the middle
     - the area for the desired height 

Choose your best fit based on these measurements. 

Cornered Column: Please give the length and width of each side. 

Cornered columns with BEVELED EDGES: We need the flat measurement of each side, and then would ALSO need the measurement of the beveled edge. Usually, all 4 beveled edges are the same but measure all of them to be sure.  

Round columns: Please give the circumference (measurement AROUND the column). The circumference of round columns should be measured using a soft tape measure. 

It is always helpful to provide photos or drawings of odd-shaped structures.

​GATE ARM PADDING​
Picture
​​Please provide measurements in inches. 

Straight Gate Arm Padding
The dimensions of the gate arm: height, width, and length you want to be covered (example: 1” wide x 4” high x 60” long). If round or octagon, provide the circumference of the arm and the length.



Folding / Articulating Gate Arm Padding
Same information as above, but separate measurements for the inner arm that is from the folding mechanism to the control base and the outer portion of the arm from the folding mechanism to the end. When measuring the gate arm we recommend leaving a 2″-3″ clearance from the folding mechanism on both the inner and outer arms to avoid possible interference when the arm is in motion.
​

BOLLARD POSTS AND LIGHT POLE BASE COVERS
​​Please provide measurements in inches. 
Measure the circumference OR diameter and height of the bollard post you want to pad. In the case of a square or rectangular post, please give the length of each side.
​
PLEASE NOTE:  When measuring, measure carefully and double check your measurements. 
​Custom pads are made to order and are not returnable.
Picture
Picture